8
EN
REMOTE SENSOR SCANNING
The unit can be set to automatically scan and display readings from
the remote sensors and indoor readings. When the remote-sensor
mode is active, the display will show the readings from one channel
for about 4-seconds and then proceed to the next channel display.
To activate the remote-sensor scanning mode:
• Press and hold IN/CHANNEL for 2-seconds.
To deactivate the remote-sensor scanning mode:
• Press IN/CHANNEL, MEMORY,
[HI/LO], [▲], [ON/OFF]
(TEMP % RH AL)
MAXIMUM AND MINIMUM
TEMPERATURE AND HUMIDITY
The maximum and minimum recorded temperature and humidity
readings will automatically be stored in the memory.
To display the maximum and minimum display memory:
1. Select the channel to be checked.
2. Press MEMORY once to display the maximum temperature
and again the minimum temperature. The respective indicators,
MAX or MIN will be displayed.
TEMPERATURE AND
HUMIDITY TREND INDICATORS
The temperature-trend and humidity-trend indicators show the
trends of collected readings. Arrows indicate a rising, steady or
falling trend.
Note: If the temperature goes above or below the temperature
measuring range of the main unit or the remote unit ( stated in
specification), the display will show “HHH” or “LLL”.
Arrow
indicator
Temperature
Trend
Rising Steady Falling
Rising Steady Falling
Arrow
indicator
Humidity
Trend
RMR132HG_M_EN_R01 8/13/04, 12:30 PM8
To Next Page
Loading...
