ORFELD B08 - Clean Filters; Clean Brush Rollers

EN
22
b) Clean lters
• First remove the dustbin (18) from the handheld vacuum and empty.
• RemoveHEPAlter(22),pre-lter(21)andmeshlter(20)insequence,andwashthemunder
running water.
 Allowalllterstoairdrycompletelybeforereplacingtheminthevacuumtopreventliquid
from being drawn into electric parts.
c) Clean brush rollers
When cleaning brush rollers (14, 15), be sure to not cut anything other than hair, string,
bres,orotherdebris.
• Firstturno󰀨poweranddisconnecttheoornozzle(7)fromthewand(5).
1. Use a coin or key to twist anticlockwise the brush roller release switch to unlock the lid.
2. Remove the lid and lift out the soft brush roller (14) by the tab on the right side.
3. Cleano󰀨anystring,carpetbres,orhairthatmaybewrappedaroundthesoftbrushroller(14),
and remove debris from the brush roller housing.
4. Wash the soft brush roller (14) as needed, using only water.
5. Air-dry completely for at least 24 hours before reinstalling.
6. Reinstallthesoftbrushroller(14)andclosethebrushrollerhousingbyxingthelidonthe
oornozzle(7).