ORFELD B08 - User Manual

Questions and Answers

V
victorgrahamJul 28, 2025
How to fix an ORFELD B08 Vacuum Cleaner that won’t turn on or charge?
- I
  ingramdonaldJul 28, 2025
  If your ORFELD Vacuum Cleaner won’t turn on or charge, it could be due to a low battery or overheating. To resolve this, fully charge the battery and let the vacuum cool down before retrying.
A
Angela KellerAug 2, 2025
Why does my ORFELD Vacuum Cleaner have a short running time?
- S
  sellersrandallAug 2, 2025
  A short running time for your ORFELD Vacuum Cleaner might be because of low power or clogged/dirty filters. Fully charge the battery and clean the filters to improve the running time.
J
Jessica TravisAug 7, 2025
Why does my ORFELD Vacuum Cleaner have poor suction?
- W
  William WeberAug 7, 2025
  Poor suction in your ORFELD Vacuum Cleaner can occur due to several reasons: the dustbin may not be seated completely or installed correctly, the filters could be clogged or dirty, the battery might be low, or the nozzle/dirt passage may be clogged. To resolve this, try the following: Reinstall the dustbin, ensuring the lid is closed completely. Clean the filters. Fully charge the battery. Disconnect the nozzle to remove any debris.
T
Terri MoodyAug 11, 2025
What to do if my ORFELD B08 suddenly turns off?
- J
  Jose WebbAug 12, 2025
  If your ORFELD Vacuum Cleaner suddenly turns off, it might be due to a full dustbin, clogged or dirty filters, or overheating. To fix this, empty the dustbin, clean the filters, and let the vacuum cool down before retrying.
R
Roberta CordovaAug 17, 2025
Why is my ORFELD Vacuum Cleaner not picking up debris?
- J
  jsmithAug 17, 2025
  If your ORFELD Vacuum Cleaner isn't picking up debris, it could be due to a full dustbin, clogged or dirty filters, or worn filters. To solve this, empty the dustbin, clean the filters, or change the worn filters.
E
Edwin Holmes IIAug 21, 2025
What to do if the brush roller on my ORFELD B08 won't spin?
- P
  Paul HowellAug 22, 2025
  If the brush roller on your ORFELD Vacuum Cleaner isn't spinning, it's likely clogged by hair, fibers, or other debris. Clean the brush roller to resolve this issue.