Oriental motor BLE2D300-C - I;O test; Electromagnetic brake test; 3. Edit lock function

Operation panel
39

I/O test
With the I/O test, the ON-OFF status of each input signal can be checked, and the ON-OFF status of each output signal can be
switched.
The ALARM LED on the driver blinks in orange when the screen is moved to the I/O test.
During the I/O test screen, the I/O terminals of CN5 are disabled, and the motor does not rotate even if the operation input signal
is turned ON.
Note
If the setting dial is pressed to move to the I/O test screen while the slight position-keeping function is enabled, the
holding force is lost.
When the screen is returned to the top screen of the test mode, the holding force is generated.
z
Input signal
Each digit on the 7-segment LED display corresponds to a signal.
The corresponding digit is lit when the signal is ON, and the digit is unlit when the signal is OFF.
The connection with a programmable controller can be checked.
In this time, the motor does not rotate even if the input signal is turned ON.
IN6
IN5
IN0
IN1
IN2
IN4
IN3
TH
z
Output signal
The ON-OFF status of the output signal can be switched using the setting dial.
z
External voltage
The voltage value input by the external analog setting device can also be checked.

Electromagnetic brake test
The electromagnetic brake can be released to bring the motor shaft in a free-run state at motor standstill even if input signals are
not connected. It cannot be executed while an alarm is generated.
Note
When a load is installed vertically, do not perform the electromagnetic brake test.
The motor loses its holding torque, and the load may fall.
3. Edit lock function
This is a function to prohibit the local control operation in addition to editing and erasing of data and parameters by the
operation panel.
Monitor mode
∗
Locking
Panel display
Lock
Press and hold the
key
(about 5 seconds)
The display blinks
several times
Monitor mode
∗
Reset locking
Panel display
Reset
Press and hold the
key
(about 5 seconds)
The display blinks
several times
*
The edit lock function can be set when the top screen of each mode is displayed.
Display while the edit lock function is enabled
If the setting value of the operation data or parameter is tried to change while the edit lock function is enabled, " " is
displayed for about one second.