To Next PageTo Next PageWhat to do if my Oriental motor Engine fails to turn on?
If your Oriental motor Engine isn't turning on, ensure that both the START/STOP and RUN/BRAKE inputs are set to the ON position. Additionally, the internal potentiometer might need adjustment; try turning it slightly clockwise, as the speed is set to 0 r/min at the factory.
Why is my Oriental motor Engine running in the wrong direction?
The Oriental motor Engine might be running in the opposite direction due to a few reasons. First, check the CW/CCW input; the motor runs clockwise (CW) when this input is ON and counter-clockwise (CCW) when it's OFF. Ensure the connection isn't faulty. Also, if you're using specific speed reduction ratios (30:1, 50:1, or 100:1 with a combination type parallel shaft gearhead, or 20:1 and 30:1 with a geared type), the drive direction will be opposite; in this case, reverse the CW/CCW input operation.
How to fix an Oriental motor Engine that won't stop immediately?
If your Oriental motor Engine doesn't stop immediately, try stopping the motor by using the RUN/BRAKE input instead of the START/STOP input. It's also possible that the load inertia is too high; try increasing the frictional load or reducing the load inertia. Finally, check the acceleration/deceleration time potentiometer to ensure the deceleration time isn't set too long.
What to do if Oriental motor Engine does not run?
If your Oriental motor Engine isn't running, ensure that the motor (gearhead) output shaft and the load shaft are properly aligned and connected. Also, check for any noise interference by running only the motor, driver, and external potentiometer. If noise is present, take measures such as separating the motor from the noise source, reconnecting the wiring, using a shielded cable, or installing a ferrite core.
General| Brand | Oriental motor |
|---|---|
| Model | BLHD15K |
| Category | Engine |
| Language | English |
General safety instructions for qualified personnel and installation.
Safety precautions during operation, repair, and handling.
Steps to check supplied items after unpacking.
Identifies and explains the functions of driver components.
Tables for allowable overhung and thrust loads for various types.
Load shaft dimensions and load limits for hollow shaft gearheads.
Guidelines for installation and wiring to comply with EMC Directive.
Overview of input/output signals and their functions.
How to use the ALARM-RESET input.
How SPEED and ALARM outputs work, including alarm codes.
Details on protection functions and their causes based on LED flashes.
How to adjust acceleration and deceleration times.
Key checks to perform after operating the motor.
Troubleshooting steps when the motor does not turn.
Troubleshooting for incorrect rotation, no run, vibration, and stop issues.
