Orion 150 HCCA - Page 12

Using the Concept 97 1 in the Master / Siave configuration
One of the very unique applications of ORION amplifiers is the
ability to control other ORION amplifier for a perfectly matched sys¬
tem. This feature is primarily used for multi-amplifier subwoofer
applications. Using the Concept 97 1 as a master amplifier can only be
performed with channels 1 & 2.
Master Configuration
The output of the MASTER amplifier is only designed to operate
with amplifier of the same model. With the Concept 97 1, the MAS¬
TER/SLAVE configuration is only reserved for channels 1 & 2.
NOTE; If the MASTER amplifier's summed mono jumper is installed
in the channels 1 & 2 jumper, all amplifiers connected to the AUX out¬
put will also be summed.
20
Siave Configuration
As a slave amplifier, channels 1 & 2 will track exactly the signal of
the master amplifier.
MASTER amplifier SLAVE amplifier
DVX-2SrotAXvr1
Note: Separate input for channels 3 & 4 can be used by removing
jumpers for 2 channel input on master amplifier.
21