Orion 150 HCCA - Signal Configuration

Tri-Mode Six Channel Operation
• Lowest recommended impedance for channels 1 & 2 is 2Q per
channel stereo and 4Q bridged mono.
• Lowest recommended impedance for channels 3 & 4 is 0.5S2 per
channels stereo and 1S2 bridged mono.
• Front and rear outputs must be set for full range operation.
• Channels 1 & 2 and 3 & 4 must be configured for stereo full-
range operation.
• Passive crossover frequencies must not overlap.
WARNING: Passive crossover overlaps may cause damage to the
amplifier.
SIGNAL CONFIGURATION
The Concept 97 1 has the ability to route very complex system con¬
figurations. We have included the most common configurations.
Additionally, an amplifier configuration diagram has been included
for your convenience. If you have any questions regarding the signal
configurations section of this manual, please refer to your local
Authorized ORION dealer or ORION'S technical support (1-800-315-
2080) for assistance.
4 Channel Input Factory Configuration
In this configuration. Channels 1 & 2 and 3 & 4 are fed separate
incoming RCA inputs. Aux output is full range copy from the input
Channels 1 & 2.