Orion 150 HCCA - Page 4

• Removable Top Panel- This provides easy access to the module
slots and signal jumpers.
• Multi-level input capabiiity- The Concept 97 1 is designed to
accommodate all different types of source units. An input range
from 150 mV to 5 Volts rms is required to achieve full power out¬
put. Your Concept 97 1 will maximize the sonic capability of your
OEM (original equipment manufacture) or aftermarket source
unit.
• TVi-Mode- The Concept 97 1 has the capability of running a
stereo output with 2 channel while bridging across them for a
bridged output at 4 tirries the stereo power for a dedicated 4£2.
Designed to work with the CSX-TMC available from WIRED! , Tri-
Mode make subwoofer systems affordable and easy to install.
• Large Efficiency Anodized Heatsink- Large C n C‘ machined
high efficient anodized aluminum heatsink incorporates a large
surface area allowing components to run cooler and more effi¬
cient for maximum performance and safe operation.
• Military Spec. Double Sided Plated Through Circuit Boards-
All ORION circuit boards are reinforced with Nickel and plated
through for greater reliability with through hole parts.
• Parallel 8 Pin DIN and RCA Inputs/Outputs- Amplifiers can be
linked together using DIN or RCA connectors for easy connection
in multi-amp systems. The 8 pin DIN connectors are backwards
compatible with all previous ORION amplifiers, crossovers and
pre-amplifiers.
• 15 Volt Phantom Power supply- On-Board power supply for
external orion signal processors eliminates grounding problems
that can cause engine noise in the system.
• No (Audio) Current limiting Circuitry- The amplifier will pro¬
duce more power into lower impedance without going into early
SVSTEM PLANNING
The Concept 97 1 meets the power requirements that allow one
amplifier to be used in the 0-150 watt class, two amplifiers in the 151-
300 watt class and four amplifiers in the 301-600 watt class. The fol¬
lowing system designed are suggestions to maximize each power dif¬
ferent classes.
SYSTEM 1
This system is designed to use a pair of NT 5S separates on chan¬
nels 1 & 2 and 2 NT 12 DVC on the bridged channels 3 & 4.
Jumper and Module Configuration
Input & Output Configuration
• IASCA Rated Power is 150 Watts
• Dynamic ORION Power is 600 Watts
• Channels 1 & 2 is operating high-pass at 40 per channel stereo
• Channels 3 & 4 is low-pass bridged into 1£2
• 2 channel input is used
• Independent gain control for channels 1 & 2 and 3 & 4
• Output for channels 3 & 4 are summed-mono
5