Orion COBALT CO 230 - POWER CONNECTIONS AND SAFEGUARDS

POWER CONNECTIONS AND SAFEGUARDS
As shown in Fig, 10 and Fig. 11, the rear face-plate projects short wires for DC power connections
and a female plug that contains speaker and Remote Turn-On connections. The 12 gauge solder-
tinned red wire (with built-in fuse holder) goes to your car's positive battery connection, while the 12
gauge black wire with lug is bolted to metal chassis for power ground (see Installation, starting page
16).
NOTE: The (+) power wire on each amplifier must be connected directly to the positive battery terminal.
Fig. 11. Rear panel layout for the Cobalt 430 amplifiers