Page 73 of 77
CLEANING, DISINFECTION, SANITIZATION
INFORMATION
SANIFICATION is the complex of cleaning and / or disinfection procedures and operations
The CLEANING is a physical and mechanical process (i.e., rubbing) with which a large part of
potential pathogenic microorganisms (bacteria, fungus, or virus), further to the visible dirt, is
removed from the surface.
The combination of mechanical action with other factors such as the use of detergents (chemical
action), temperature and duration can efficiently and sufficiently reduce the microbial load of the
device.
DISINFECTION, after cleaning and cleansing, further reduces the number of microorganisms on a
surface and it eliminates pathogenic microorganisms, ie bacteria causing disease and viruses.
Products that on the label bear the authorization / registration Number of the Ministry of Health or
other competent authority of an EU member State. are "disinfectants". Each disinfection action must
always be preceded by a cleaning and cleansing operation, since dirt reduces the activity of the
disinfectant. DRYING is essential because microbial growth can occur in the residual aqueous film.
CHEMICAL PRODUCTS WITH VIRUCIDAL-GERMICIDAL-FUNGICIDAL EFFICACY are available
on the market for hospital equipment. These products are effective in cold conditions, able to
perform cleaning (elimination of dirt) and disinfection (elimination of pathogenic microorganisms, i.e.
bacteria causing disease) in a single operation. and viruses).
Removable UPHOLSTERIES are washable respecting the symbols on the label.
Washing is an extraordinary sanitation measure. Replace them when worn / difficult to sanitize.
WARNINGS
Read the TECHNICAL SHEET of the chemical product to verify that it is suited to be used on
chrome plated/varnished surfaces and on plastic components in PVC, PA, PP and to test on a small
surface to ensure that it does not damage the aid.
For an effective operation, it is important to RESPECT THE POSOLOGY and TIMES OFACTION
indicated on the product LABEL.
Use the PPE (gloves, FFP mask, visor, etc…) required on the product LABELP
The operations of sanitization must be performed without the user inside the
device. Do not use compressed air, which can cause aerosol and contamination of
possible virus and bacteria in the environment and on his own person.
During the Covid-19 epidemic, the contaminated PPE (gloves, gowns, glasses,
masks, caps, etc…) must be thrown away in the general waste bin, unless
otherwise indications by the belonging municipality
To Next Page
Loading...
