Ortovox 3+ Manual Guide

 EN
+



SWITCHING ON
Turn the ON/OFF switch () counter-
clockwise. The rotary switch clicks into
the position “I” and is now secured against
being unintention-ally switched o.
SWITCHING OFF
Undo the unlocking slide () and
turn the ON/OFF switch () clockwise
to the position “O”.
INITIAL USE
INSTRUCTIONS
After switching on the +, the -digit
serial number appears.
The automatic self-test begins with the
display check.
The transmitter, receiver, smart antenna,
and sensors are then tested.
The remaining battery capacity is also
displayed as a percentage (e.g. “”).
For further information about the battery, see p. 
The installed software version then follows
(e.g. “.”).
SELF-TEST, TRANSMISSION MODE (device in transmission mode)
OX-GAL-3+-BUCH-vh.indd 32 06.06.13 15:26

Ortovox 3+ Specifications

General

Frequency	457 kHz
Number of Antennas	3
Marking Function	Yes
Multiple Burial Indication	Yes
Operating Temperature	-20°C to +45°C
Digital Search Strip Width	40 m
Waterproof	Yes
Battery Life	250 hours in send mode
Weight	210 grams (including battery)