+
EN
FAULT
INSTRUCTIONS
If a malfunction or fault is detected during
the self-test, “EE” appears on the screen.
A warning can be triggered in the immediate
vicinity of a transmitting avalanche transceiver,
mobile phone, wireless appliance, large metal
objects, or particularly strong magnetic fields.
If the malfunction warning is displayed during
the self-test, then carry out the test again in
the open in surroundings without interference.
When doing so, it is essential to make sure that no other transmitters are
nearby. SWITCH OFF all SOURCES OF INTERFERENCE (mobile phones,
wireless devices etc.) or move them well away.
If the warning is displayed again, the device must be sent to the ORTOVOX
service department.
Further information about the service department can be found on p.
During the partner check, the transmission
signal of the other participants’ avalanche
transceivers is checked.
•Before switching on, switch the + into
search mode by pushing apart the two
sliding switches () simultaneously. The
transmission switch over button () appears.
PARTNER-CHECK
OX-GAL-3+-BUCH-vh.indd 34 06.06.13 15:26
To Next Page
Loading...
Need help?
General
