EN
+ INSTRUCTIONS
< m
< m
X
SIGNAL SEARCH
Search the avalanche debris in
the indicated manner during the
signal search.
When using the +, a search
strip width of m (equates to
- steps) must not be excee-
ded. The distance from the edge
of the avalanche must remain
less than m.
At the same time, keep an eye
out for objects or partially buried
victims.
VICTIM’S POINT OF
DISAPPEARANCE KNOWN
If the point of disappearance is
known or objects are visible, the
search area is narrowed down to
below this point in the avalanche
flow direction.
This can save valuable time.
Simultaneously press apart
both SLIDING SWITCHES ().
The TRANSMISSION SWITCH
OVER BUTTON () springs up.
The search situation is automatic-
ally displayed on the screen.
SEARCHING - LOCATING - RESCUING
OX-GAL-3+-BUCH-vh.indd 36 06.06.13 15:26