50
a. b. c.
fold the left wing
WITH the YELLOW
eyelet!
Please note MAINTENANCE AFTER AVALANCHE
DEPLOYMENT on page 54!
1. Unscrew the used cartridge from the
AVABAG system (P).
2. Open the valve safety fastening (D) in the main
compartment (Z1) of the AVABAG backpack (see
page ). To do this, release the highlighted, orange
hook and loop fastener and pull the valve safety
fastening downwards.
3. Deflate the AVABAG balloon completely (N) using the
deflation valve (R), by pressing the deflation mark
(E) on the outside of the AVABAG backpack.
RE-USE AFTER ACTIVATION
4. Move the AVABAG compartment(Z2) zipper to the
beginning of the burst zipper (A). For this to work,
the burst zipper (A) must be completely separated.
5. With the shoulder straps to the bottom, lay the
backpack on a clean surface that is free of sharp or
pointed objects and spread the AVABAG balloon (N)
out flat.
6. Fold the airbag following illustrations a. to e.,
always using a zigzag concertina fold.
Make sure, as shown in b. & d., to fold the outer
wings WITH the AVABAG eyelets (S).
In steps c, d (second image) and e, the folds should
be about HAND WIDTH.
To Next Page
Loading...
Need help?
General
