12
34
5
6
7
8
9
10
11
13
15
17
18 19 20
21
23
24
25
12
16
OK
22
22
14
9
English
OPERATING INSTRUCTIONS
Mounting the strap
Compaction
Baling
Make sure that the press
plate is lowered.
Open the upper and lower
doors fully.
Place the straps in the
strap holders, pull the straps
through the loops and behind
the pin at the back of the
chamber.
Close the doors.
Run the press plate up.
Open the doors fully.
Fasten the straps with a loop
at the bottom of the chamber.
Place the straps in the strap
slots with the bale tool.
Close the doors.
1
2
3
4
5
6
7
8
9
WARNING!
Only the operator
is allowed in the
machine’s working
area!
Open the upper door.
Place the waste evenly
distributed in the chamber.
Close the upper door
- The start button lights
green.
Press the green start button
for an automatic press cycle.
10
11
12
13
The yellow lamp fl ashes for
ready bale - the machine is
ready for baling.
Open the upper door.
Pull the straps over the bale.
Cut the straps with the knife.
Close the upper door.
Run the press plate down
using the down arrow. The
press plate automatically
stops in the down position
and keeps the bale UNDER
PRESSURE.
Open the upper and lower
doors FULLY.
Tie the straps.
Check that the end of the
pressure rod on the upper
side of the press plate ends
at the OK arrow.
The operator stands at
the SIDE of the machine,
outside the risk area.
Make sure that nobody is in
the risk area!
Remove the bale by press-
ing the two buttons on the
side of the machine at the
same time.
14
15
16
17
18
19
20
21
22
23
24
25
Mounting the strap
Compaction
Baling
3
To Next Page
Loading...
Need help?
General
