Hydraulic oil
VG 32-68
<+4°C
LE 6520
SAE 5-20
4
1
2
SAE 20
=
=
5
3
>+5°C
0
OFF
12
SAFETY CHECK
- Check the upper and lower door switches: It must not be possible to start the machine if a door(s) is open.
- Check the baling push buttons: It must not be possible to remove the bale from the machine with only one push
button.
- Check that the emergency stop is working.
- Check that the plate that connects the cylinder and the press plate is mounted (see fi gure 2 above):
If any faults are discovered in the functions listed above, the machine must not be used until it has been repaired by
authorised service personnel.
Service and repairs are only to be performed by qualifi ed and competent staff, and in accordance with the machine
manufacturer’s instructions.
NOTE! During inspection and maintenance, service
work and the removal of trapped waste etc.:
• Always turn the main switch to ”0” and secure it
with a padlock.
• Do not work inside the machine
WEEKLY INSPECTION AND MAINTENANCE
Oil change: Contact the local authorities for advice regarding how to reduce the environmental impact when dealing
with residual oil.
English
6
To Next Page
Loading...
Need help?
General
