15
English
SAFETY FEATURES
The machine is equipped with the following safety features:
A door and a magnet switch that prevent access to moving parts during compaction (PL=d).
A hatch and a magnet switch that prevent access to moving parts during compaction (PL=d).
Excess mechanical movement in the actuator hinge that reduces the likelihood of anyone becoming
trapped in the feed hatch (PL=b).
A current measurement function in the control system that prevents anyone from becoming trapped in the
feed hatch (PL=b).
RANGE OF APPLICATION
The machine is an electrically operated waste compactor intended for compacting bulky material such as
cardboard, paper and non-rigid plastic. The machine must only be used in areas that are provided with a roof,
normal lighting and protection against wind, and that are well protected from vibration and impact. The machine
must only be used in the immediate vicinity of the operation and with daily inspection. The machine is intended to
be used in the temperature range from -10°C to +40°C/14°F to 104°F. The machine is not intended for permanent
electrical connection. If there is a risk that the machine will be used in a humid environment, the installation should
be provided with a residual current device. The machine should always be connected to an earthed electrical
socket.
The machine is available in two basic variants: one for free-standing positioning, and one for xed wall-
mounting.
Materials that are ammable or of an explosive nature, such as pressurised containers or similar, which
could cause injury, damage, re or an explosion if exposed to pressure or sparks, must not be compacted
in the machine.
The user is expected to be the general public, including minors, and personnel working at the respective
company/establishment.
In the event of the machine being scrapped, the applicable environmental legislation relating to disposal
and recycling should be complied with. The frame of the machine is constructed mainly from sheet steel,
and the outer casing from ABS plastic. The circuit board, actuator, cables and sensors are electronic. The
circuit board includes a removable battery. Contact your nearest recycling facility for guidance on handling
waste products.
3
To Next Page
Loading...
Need help?
General
