EasyManuals Logo

OSD Audio iDSP User Manual

OSD Audio iDSP
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
iDSP INSTALL GUIDE
Boomy Region – Suitable most types of subwoofers, this mode will retain the original ‘punch’ of your subwoofer, but
removes the most obvious and undesirable response issues from room reections. The Boomy Region mode will correct
the frequency response to t the ideal at line from 70 Hz and up, which is where the most annoying room reections are
likely to occur.
Choose this mode if unsure of which mode to use.
Near Field – Suitable for any subwoofer, this mode will t the response of your listening position to match the near eld
response of your subwoofer. Near Field mode only eliminates room reections and does not alter the initial response of
your subwoofer. This mode simulates what it would be like if you moved your subwoofer into your listening position.
Linear - Suitable for high class and high-performance subwoofers, this mode will equalize the entire frequency spectrum
of your subwoofer’s response to create an ideal, at response, much like what is found in mastering studios. This mode
will signicantly reduce the effects of room reections and also will equalize the initial response of your subwoofer to an
ideal at line. This mode might result in less “punch,” but it is a more accurate sound suitable for audiophiles or audio
professionals. Using the Linear mode is a good starting point for further EQ customization.
3) Once you have nished taking your averages and press “no, next” you will see the following screen. The DSP
calculates what lters are necessary to correct your response and then applies them. While this is taking place, keep your
phone in your listening position. The app will immediately take another measurement once it’s nished calculating to show
you the nal results of your room correction. If you took measurements from a wide range of positions in your room for the
2nd step, this measurement might not be totally reective of how successful the correction was, as this nal measurement
is only taken in one spot.
Start Near Field correction. Near Field correction is complete.
iDSP manual rev1 simon.indd 16 12/7/20 8:28 AM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the OSD Audio iDSP and is the answer not in the manual?

OSD Audio iDSP Specifications

General IconGeneral
BrandOSD Audio
ModeliDSP
CategoryStereo System
LanguageEnglish

Related product manuals