OSIM uAlpine Smart 2 - Operation

9
Operation
To switch on/off power
• Connect the power plug to the electrical
outlet and turn on the power switch.
• Press [ ] button to power on the uAlpine
Smart 2 and there will be 1 ‘beep’ sound.
• The sensor will take approximately 10
seconds to warm up before detecting
the PM2.5 air quality and displaying the
values after.
• The sensor will take approximately 3
minutes to warm up before detecting the
VOC air quality and displaying the values
after.
• The air quality light indicator will then
light up in Green, Yellow or Red colors,
representing air quality level from best to
worst respectively.
• Once product is turned on, the UV, Ionizer
and Auto mode functions are turned on by
default.
• Press [ ] button to power off the uAlpine
Smart 2 and there will be 1 ‘beep’ sound.
To switch on/off UV light
• Press [ ] button to turn On/Off the UV
function.
• [ ] indicator will light up/off to indicate
UV function is turned On/Off.
To select fan speed
• Press [ ] button and toggle to the
desired fan speed (Sleep mode, I, II and
III).
• Once sleep mode is selected, only the
sleep mode LED indicator [ ] will be light
up. The other LED indicators will not light
up.
• When in Sleep mode, pressing any
button will light up the control panel and
LED screen. This does not activate any
function.
To select auto mode
• Press [ ] button and the fan speed
will adjust automatically based on the
detected PM2.5 and VOC air quality. The
Auto mode will toggle through speed I, II,
and III based on detected air quality, and
will not activate Sleep mode.
To switch On/Off Child lock
• Press and hold [ ] + [ ] buttons for 3
seconds. There will be 1 ‘Beep’ sound to
indicate Child lock function has turned On/
Off.
• Once turned ON, [ ] indicator will light
up and at the same time other buttons will
be deactivated.
To select timer
• Press [ ] button and toggle to set timer
function at intervals of 1hr, 2hrs, 4hrs, 8hrs
and off.
• Respective LED indicator will light up.
To switch on/off Ionizer function
• Press and hold [ ] + [ ] buttons for
3 seconds to turn On/Off the Ionizer function.
• [ ] indicator will light up/off to indicate
Ionizer is turned On/Off.