14
Installation of main unit
Type A: For taps with a round spout
• Slip the Type A adaptor
over the spout.
• Pass the attachment nut over
the tap.
• The uPure 2 is now ready
for use.
• Tighten the attachment nut
to prevent water leakage.
2
• Measure the spout diameter
and select a Type A adaptor.
(Make sure the spout is not chipped or
cracked, as this can cause water leakage.)
• Remove the attachment nut
and Type A adaptor from the
uPure 2.
1
Type A
adaptor
Attachment
nut
Preparation before use
3 4
5 6
To Next Page
Loading...