Air lter
Air lter. Cleaning and maintenance
The air lter should be controlled periodically. Detach the upper
section of the motorcycle to reach the lter box. Remove the sensor
on the lter base and the clasp. Then remove the lter, according to
the illustration. To clean, use water and detergent, leave to dry and
then lubricate with a special liquid for lters. Reassemble using the
steps outlined previously but in reverse. Make sure that the parts are
put in their correct positions.
Carry out a regular and thorough maintenance of
your motorcycle. Always use original spare parts and
top quality products to ensure that it works correctly.
36 User manual
Radiator
The radiator contains the engine refrigerant. To fill up with or add
refrigerant to the radiator, locate the tank lid. To locate this lid,
detach the air filter lid (see page 36 - Air Filter). Once the filter lid is
detached, the radiator lid is visible. Unscrew the lid and pour in
refrigerant.
The radiator has an electric fan to force air through it, as can be seen
in the image below.
To ensure that the motorcycle works correctly, periodic controls
must be carried out to check the refrigerant levels. This will ensure
that the motorcycle is running at an optimum temperature.
ATTENTION: Use gloves. Do not open the lid if the
engine is hot. This could cause burns. Avoid contact of
the liquid with the eyes, mouth or nasal passage. Do
not ingest. In the event of this happening, follow the
product instructions and consult a doctor.
To fill the radiator, special refrigerant should be used -30ºC.
Always use special refrigerant for light alloy engines.
User manual 37
User manual 39
To Next Page
Loading...
