Cleaning the motorcycle and lubricating the mobile parts will help
protect the motorcycle and guarantee that it works better.
Lubricate using specific products:
1.Transmission chain
2.Clutch and brake lever joints
3.Gear lever joints
4.Rear brake pedal joints and bearings
5.Footrest brackets and springs
6.Engine kick-start pedal joints
7.Gas handle (right grip)
Take care NOT to accidentally lubricate the brake
caliper or brake pads. If this happens clean off the
lubricant and carry out controlled braking until the
brakes work correctly again.
If using a high pressure hose to clean the motorcycle, bear
in mind that the water pressure might rip off the stickers
or cause damage to the motorcycle. To prevent this, hold
the hose at a distance of 30-40 cm from the motorcycle
and take extra care on delicate parts.
Use specific lubricants for each part of the motorcycle.
Clutch and brake lever joints
40 User manual
Lubrication of moving parts
Gear change lever joints
Rear brake pedal joints and bearings
Chain drive
The chain must be lubricated using special oil for chain
drives.
The chain drive should always be well lubricated.
Check it each time the motorcycle is used and apply
lubrication when necessary.
User manual 41
Lubrication of moving parts
User manual 43
To Next Page
Loading...
