[5] PARALLEL I/O Connector This is a standard Otari parallel I/O interface connector.
[6] SERIAL I/O Connector These connectors provide serial remote control of transport and audio
channel modes.
[7] REMOTE Connector This connector is used for Remote Controllers (e.g., CB-147).
[8] AUTO LOCATOR Connector This connector is used for the CB-148 Auto Locator.
[9] POWER Connector This connector is the AC power input connector.
[10] GROUND Terminal This is the ground terminal.
Section 3 Controls and Indicators
3 - 6
October 1990
MTR-90III Operation and Maintenance Manual
To Next Page
Loading...
