OTC 3109N - On-Board Systems Control; On-Board Systems Test

16
On Non-CAN vehicles the Tool displays:
 test data (test ID)
 maximum value (MAX)
 test measurements (MEAS)
 minimum value (MIN)
 status (STS)
 measurementsandspecicationvaluesarehexadecimal
numbers (i.e., $1A, $FE, $11.)
 module (MOD)
OR
On CAN vehicles the Tool displays:
 Test performed. The test performed can be $## if test is not
dened.Refertovehicleservicemanualfordetails.
 Measured values and units of measure (such as volts, amps,
seconds).
 Status of monitor test data.
 Module ID where the monitor test data came from.
On-Board Systems
The On-Board Systems test allows the Tool to control operation of
vehicle components, tests, or systems.
9 Some manufacturers do not allow tools to control vehicle
systems. A vehicle not supporting an on-board system is
identiedbyamessagedisplayedwhenselected.
9 Refer to the appropriate vehicle service manual for on-board
systems instructions.
9 After selecting On-Board Systems, a list of on-board
systems and components available for testing are shown on
the display.