ConnectClip
Quick guide to the remote microphone
Power indicator
Status indicator
Multi-button
Volume down
Rotating clip
Microphone
Charging socket
Volume up
• Press the multi-button for 3 seconds, until the power
indicator (right) shows steady green
• When the status indicator (left) shows steady yellow or
blue, ConnectClip is connected to the hearing aids
• Select the remote microphone mode by pressing the
multi-button for 3 seconds, until the status indicator
shows steady magenta
• To mute/pause the remote microphone streaming, press the
multi-button for 3 seconds. The status indicator (left) changes
to steady yellow or blue
• To unmute/restart streaming, press the multi-button for 3
seconds, until the status indicator shows steady magenta again
• Turn ConnectClip off by pressing the multi-button for
6 seconds, until both the power indicator and the status
indicator are off
2
Microphone
mode
1
Power
on
3
Mute
4
Power
off
TIP
Check that the status indicator is
magenta and the power indicator
is green – especially if you have
been out of range.
Attach to the person speaking
Attach the ConnectClip to the speaker’s
clothing about 8 inches below their mouth.
Make sure the microphone is pointing
towards the mouth and is not covered by
clothes or in a shirt pocket, etc. You can
also use the lanyard provided to hang the
ConnectClip over the speaker’s clothes.
To Next Page
