USER MANUAL
OTTERSPOT WIRELESS CHARGING SYSTEM
Works with Apple, Samsung, Google and other certified Qi Wireless enabled phones
1. Powered by 36 watts of USB-C power delivery, OtterSpot Charging Base delivers high-speed charging as the foundation of the
system. Designed to blend in, the charging base becomes your central location for charging your phone and OtterSpot batteries.
2. While the charging base charges a stack of batteries, it can also be used as a stand-alone Qi Wireless charging pad that holds
your phone in place on its anti-slip surface.
Note: When it’s plugged in, the base is always on. So there’s no need to press a button to enable wireless charging. Your wireless
enabled device begins charging right away when you place it on the base’s surface.
Note: You can expect to charge up to three OtterSpot batteries (consumer version) at once with a max charging rate (4.5 hours to
full), or up to five commercial batteries at max charging rate (4.5 hours to full) when charging in a stack.
3. Expand your OtterSpot Wireless Charging System with up to three OtterSpot batteries to keep everyone who needs it fully
charged.
Note: Devices have built-in safety measures to allow for a certain amount of charging speed. For example, iPhone X has 7.5W
charging ability while the Samsung Galaxy S9 has up to 10W. However, this product does NOT harm a device due to its higher
wattage output. The wireless charging features on both the base and the battery only charge up to 10W max power.
USE OTTERSPOT BATTERIES
1. OtterSpot batteries deliver a fast charge wherever and whenever you need it, with a battery capacity of 5000 mAh — enough
energy to charge most devices up to one full recharge.
2. OtterSpot batteries cannot be charged wirelessly. You must either stack them on top of the charging base or charge it with a
USB-C cable via its backside port (much like any other battery pack).
3. Once you’ve charged your OtterSpot batteries — remember, you can stack up to three of them on the charging base (five on
commercial base) — simply place them on a flat surface in and around your home or on the go. Then place your phone on top of
one to begin charging.
Note: The button must be pressed to enable wireless charging. The battery goes into an idle state after about 40 seconds when
not in use to conserve energy.
4. OtterSpot batteries also hold your phone in place with their anti-slip surface.
To Next Page
Loading...
Need help?
General