label icons for users' selection. When reaching the set time, the watch will vibrate and show the label
of the alarm clock as shown in Figure 2-2-1 and the watch vibrates for ten times and goes dark for
standby. (If the set time of the single alarm clock is in conflict with that of the multiple alarm clocks,
the device will preferentially show the single alarm clock).
(Fig. 2-2-1)
2.2. Call Function
(1) Function Introduction: The function switch can be set in the APP. When it's set as "ON",
there is an incoming call for the mobile phone and the watch vibrates (for IOS, there will only be
reminder when there is the connection with the mobile Bluetooth), shows the call sign and the caller
ID (If there is the recorded ID in the mobile phone address book, the caller name will be shown).
2.3 Reminder of Short Message/Mobile Phone Application
(1) Function Introduction: The function switch can be set in the APP. When it's set as "ON",
when there are short messages of the mobile phone or the pushed notifications of the mobile phone
application (Facebook, QQ and others), the watch shows the pushed contents (necessary pairing for
IOS, open permission for Android, and the device will normally prompt the pushed contents) as
shown in Figure 2-2-2.
(Fig. 2-2-2)
3. Other Functions
3.1 Wearing Detection
(1) Function Introduction: The function switch can be set in the APP. When it's set as "ON", the
watch will firstly conduct the wearing detection to determine that the users wear the watch correctly
before heart rate (blood pressure) measurement. If it's correct wearing, then the heart rate (blood
pressure) measurement is started. If it's not qualified, then the induction lamp will blink for a while
and light off automatically and the watch will go dark for standby.
3.2 Female Functions
Function Introduction:
a. The functions are for women only. When the users are male, the APP will show no any
To Next Page
Loading...