Remark:
Connectors and Wire colors could be customized
5)
Installation
●
Install the display in the middle of handlebar, then adjust
to suitable
angle, install the press button to left side
ofhandlebar.
●
Power off the device, connect the device to controller.
●Power on
1) UART protocol:
Equipped with independent press buttons
2) Speed:
Real-time SPEED,
3) kmh/mile:
3
Connectors and Wire colors could be customized
Install the display in the middle of handlebar, then adjust
angle, install the press button to left side
Power off the device, connect the device to controller.
2. Overview of S700
Equipped with independent press buttons
, Average SPEED
Connectors and Wire colors could be customized
Install the display in the middle of handlebar, then adjust
angle, install the press button to left side
Power off the device, connect the device to controller.