Need help?Do you have a question about the Outback Power Systems HUB10 and is the answer not in the manual?
General| Series | HUB |
|---|---|
| Model | HUB10 |
| Dimensions | 8.0 x 7.0 x 2.2" (20.3 x 17.8 x 5.6 cm) |
| Weight | 1.8 lb (0.8 kg) |
| Supported Systems | Outback Power Systems |
| Ports | 10 |
Essential safety warnings for handling electrical components and installation to prevent injury.
Notes on grounding, enclosure, wiring, and building codes for proper system installation.
Details the HUB 4 and HUB 10 models and their respective port configurations.
Lists the CAT5e cables and bushings supplied with the HUB.
Instructions for wall-mounting the HUB to enclosures or other surfaces.
Diagram illustrating the HUB 10's port layout for connecting devices.
Describes the HUB's power-up sequence and LED indicators during operation.
Connecting a single FX or Charge Controller to the HUB.
Connecting multiple OutBack Charge Controllers to the HUB.
Wiring FX Inverters for series or parallel stacking configurations.
Wiring FX Inverters for three-phase system integration.
Explains the sequence of screens displayed when the MATE powers up.
Procedure to update the MATE after adding or repositioning devices.
Solutions for HUB power, MATE connection, and device recognition errors.
Steps to identify and correct communication errors shown on the MATE.
To Next Page