ASSEMBLY INSTRUCTIONS
10
TM
USE OF PUMP
Pump Installation
7. From inside the Skimmer Canister
9
, snap the pins of the Weir
8
into the
pivot slots, one after another. The Weir should now stand upright but not stick.
8. Slide the Top Cover
5
closed onto the Skimmer Canister
9
.
5
9
Inside Pool Wall
Weir installation
finished.
a) Insert one Weir
pin into one hole.
b) Push to secure
the connection.
c) Repeat for other pin.
Push here
Push-in
9. You can now fill the pool with water up to between the MIN and MAX markings on the inside of Skimmer Seal Ring
d
.
Max. Level
Min. Level
Inside Pool Wall
The water level should be
between the min and max
markers located inside the
Skimmer Seal Ring.
1. Plug the Power Cord Set
j
to a properly grounded receptacle.
2. From inside the pool, check if the water flow from the RF Diverter
p
is correct. It should feel like a solid stream of water returning to the pool.
If not, or if you feel a reduction in flow, clean or replace the Filter Cartridge
7
. For details, see FILTER CARTRIDGE USE & CARE (p. 11) as well
as Problem 2 of TROUBLESHOOTING GUIDE (p. 17).
3. To turn the Pump off, unplug from the power outlet.
4. VERY IMPORTANT: Check and adjust the pH and chlorine levels daily. THE FILTER PUMP ALONE WILL NOT PREVENT ALGAE FROM GROWING
IN THE POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES. For details, see
POOL WATER CARE (p. 12).
To Next Page
Loading...
Need help?
General