Outbound SKIMMERPLUS SFX600

Questions and Answers

C
Craig JonesAug 4, 2025
How to troubleshoot Outbound Swimming Pool Pump motor that does not start?
- I
  ipetersenAug 4, 2025
  If your Outbound Swimming Pool Pump motor doesn't start or kicks on and off, there are several potential causes: * The pump might not be plugged in. Ensure the Power Cord Set is plugged into a grounded power outlet. * The Power Cord Set or circuit breaker may have tripped. If the problem continues, have a qualified electrician check the circuit. * There could be low voltage. Verify that the line voltage is between 105 V AC and 125 V AC.
A
Adam SpencerAug 12, 2025
Why is my Outbound Swimming Pool Pump not cleaning the pool properly?
- S
  Susan SnyderAug 12, 2025
  If the Outbound Swimming Pool Pump is not cleaning the pool properly, resulting in cloudy or green water, consider the following: * Maintain the chlorine level between 1.0 and 1.6 ppm. * Keep the pH level between 7.3 and 7.8. * Clean or replace the filter cartridge. * Inspect the cartridge for damage and replace if necessary. * Check for obstructions at the strainer basket, filter cartridge, hose, and return fitting. * Have your pool water tested by a pool supplies store to check if other chemicals are required. * Clean the pool and filter more often, as chemicals are essential for maintaining clean pool water.
J
Joseph GutierrezAug 27, 2025
How to increase water flow in my Outbound Swimming Pool Pump?
- B
  browndianaAug 27, 2025
  If you're experiencing no or slow water flow from the return fitting of your Outbound Swimming Pool Pump, consider the following: * Ensure the water level is between the MIN and MAX lines on the skimmer seal ring. * Check for any obstructions at the strainer basket, filter cartridge, hose, and return fitting. * Clean or replace the filter cartridge. * Refer to the pump servicing instructions to clean any dirt blocking the motor rotor.
T
tharrisNov 19, 2025
What to do if Outbound Swimming Pool Pump is leaking water?
- C
  Cory PadillaNov 19, 2025
  If you're experiencing water leakage with your Outbound Swimming Pool Pump, here's what to check: * Ensure the hose connections with the skimmer canister and/or 90° elbow are secure. Verify that the hose clamps are properly tightened over both the hose and the hose connection O-rings; adjust and retighten if necessary. Also, inspect the hose for cracks or holes and replace it if needed. * For leakage at the bottom of the canister, refer to STEP 3: Pump Reassembly/Replacement, p. 15-16: 1 B1. The Canister Gasket must sit in the groove (inner groove for SFX600/SFX1000) on the bottom of the Canister before installing the pump. B2. Check Pump alignment. The arrow of the Pump indent (marked 'ALIGN') MUST point to the Canister indent (only visible from bottom). 1 B3. Make sure the Motor Sea...