Form No. OVCM-0720
4
IMPORTANT SAFETY INFORMATION
MODEL DESCRIPTION
All Models
Ovention
®
Conveyor Ovens are designed to provide unequaled
flexibility in both kitchen and front-of-the-house installations.
The superior cooking control, small footprint, low heat escape,
and option for hood-less installation make the Conveyor Oven
a modern solution for ease of operation and high throughput.
Each Conveyor Oven is equipped with dedicated upper and
lower heating elements and air blowers. The air blowers direct
heated air through upper and lower jet plates inside the oven
chamber, above and below the food. A conveyor belt moves
product continuously from one side of the conveyor, through the
oven chamber, to the opposite side of the conveyor.
Operator controls consist of a touchscreen, a Standby switch,
and a Main Disconnect switch. Adjustable door tunnels on each
side of the oven chamber can be used to customize the chamber
opening height. Two removable crumb trays, one below each
side of the conveyor, allow for easy cleanup. A USB port allows
the uploading of pre-programmed menu items, installation of
(1829 mm) cord and plug set is standard.
Model C1400
Model C1400 is a standard, single belt conveyor oven. It has a
to-right or right-to-left.
Model C2000
Model C2000 is a standard, single belt conveyor oven. It has a
to-right or right-to-left.
Model C2600
Model C2600 has three different conveyor oven configurations—
single belt, 50/50 split belt, and 70/30 split belt. The split belt
models allow two different cook durations (belt speeds) to be
running at the same time.
can be set to cook from left-to-right or right-to-left.
Two 12" (304 mm)
Conveyor Belts
The 50/50 split belt model
(304 mm) conveyor belts.
Each can be operated
independently and can be
set to cook from left-to-
right or right-to-left.
17" (431 mm)
Conveyor Belt
8" (203 mm) Conveyor Belt
The 70/30 split belt model
(203 mm) conveyor belt.
Each can be operated
independently and can be
set to cook from left-to-right
or right-to-left.
Touchscreen
Standy Switch
Crumb
Tray
USB Port
Conveyor
End Stop
Conveyor Belt
Conveyor
End Stop
Adjustable
Door Tunnel
Main Disconnect Switch
(located on side)
Oven Door
Left Side of
Conveyor Assembly
Oven Chamber
Right Side of
Conveyor Assembly
Model Description (Model C2000 shown)
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
NOTICE
Do not lay unit on front or back side. Damage to unit could
occur.
Clean unit daily to avoid malfunctions and maintain sanitary
operation.
To Next Page
Loading...
