This is programmed for charging Pb batties with nominal voltages from 2 to 20V. Pb batteries
cannot be charged rapidly as they can only deliver relatively low current compared to their
capacity. The optimal charge current will be 1/10 of the capacity. Please follow the instructions
supplied by the battery manufactuer
Pb mode is for charging Pb batteries only. You
can set up the charge current using the settings.
It is possible to set the Pack./
CAPAC/CURR/ENDV for the battery. The
charge current ranges from 0.1-10.0A and the
voltage needs to be matched with the battery
being charged. Start the charge process by
pressing the “Enter” key for more than 2
seconds
Set the cell count, discharge current and battery
capacity in this menu. The discharge current
ranges from 0.1-2.0A and the voltage should be
matched with the battery being discharge. Start
the discharge process by pressing the “Enter”
key for more than 2 seconds
The screen shows the state of the charge/
discharge process. To stop the process, press
“Back” key once.
To Next Page
Loading...
Need help?
General