Why am I not getting motion detection notifications from my Overmax Camspot 4.7 Pro Security Camera?
If you are not receiving notifications when the Overmax Security Camera detects movement, ensure that push notifications are enabled both on your phone and within the app.
What to do if my Overmax Camspot 4.7 Pro Security Camera won't connect to WiFi even with the correct password?
If your Overmax Security Camera fails to connect to the 2.4 GHz WiFi network after entering the correct password, verify that your phone and the camera are connected to the same network. Also, make sure that DHCP protocol is enabled and that the WiFi signal is strong. You can also try resetting the device by holding the reset button for 5 seconds.
How to reset Overmax Camspot 4.7 Pro to factory settings?
To reset your Overmax Security Camera to factory settings, either remove the camera from the device list in the application or press and hold the reset button for 8 seconds until you hear a beep.
How to change the router connected to my Overmax Camspot 4.7 Pro Security Camera?
To change the router your Overmax Security Camera is connected to, remove the camera from the device list in the application, or hold the reset button for 8 seconds until you hear a sound. Then, set up the device again.
What to do if my Overmax Security Camera doesn't recognize the microSD card?
If your Overmax Security Camera doesn't recognize the microSD card, check the camera settings to ensure that saving of image and sound material to the microSD card is enabled. The device supports memory cards with a capacity of up to 128 GB.
General| Night Vision | Yes |
|---|---|
| Wireless | Yes |
| Two-way Audio | Yes |
| Storage | MicroSD card |
| Memory Card Slot | Yes, microSD up to 128GB |
| Resolution | 2304 x 1296 px |
To Next Page
