overstock BAR STOOL - Step 2; Step 3

Step 2
3.1 Position the assembled component upright.
Align Wooden Leg (B) top end to the notch of the Swivel Plate (D).
3.2 Then, affix the Wooden Leg (B) and Swivel Plate (D) with Bolt② , Spring Washer④ , Flat Washer …⑤
, Allen Key  by using Hardware Pack B.
Place and partially screw in all bolts.
Then fasten the Bolts,DO NOT FULLY TIGHTEN THE BOLTS.
Repeat the same process with the remaining legs.
3.1
Place the Wooden Leg (B) and Leg Frame (C) on a clean, non-marring surface to avoid any scratch or
damage to the product.
Pick up one Wooden Leg (B) and align to the notch at the Leg Frame (C).
use the Bolt •①, Spring Washer④ „, Flat Washer …⑤, Allen Key⑦ by using Hardware Pack A.
Repeat the same process with the remaining legs.
At this stage, DO NOT FULLY TIGHTEN these Bolts.
WARNING ! FULLY TIGHTEN COULD LEAD TO DAMAGE OF THE PRODUCT .TIGHTEN ONLY
UNTIL SECURE AND STABLE.
Step 3
3.2
Pack A
Pack B
Page 5 OF 8