Ensure that all the Bolts are fully driven in and locked in.
Turn this Bar Stool/Counter Stool right way up and ensure this Bar Stool/Counter Stool is stable.
Place the Bar Stool/Counter Stool on a level Surface to check if it wobbles.
If it is wobbles, lift the Bar Stool/Counter Stool some 30cm to 50 cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop chair freely and vertically,with the four legs hitting the ground at the same time.
This Drop Test will help to ensure that all the Bolts and gaps to all reach full alignment status.
Test again for evenness on a Level Surface.
If no wobbles are found, proceed to tighten all the Bolts.
Caution: When tightening the Bolts, tighten sequentially.
Do not fully tighten PACK A& PACK B during Step 2 and Step 3 and then towards the next one.
This may cause the frame to warp.
If there is still wobbles, loosen the bolts PACK A& PACK B during Step 2 and Step 3. and execute
this same drop test.
WARNING !! DO NOT FULLY TIGHTEN PACK A& PACK B during Step 2 and Step 3.
FULLY TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
TIGHTEN ONLY UNTIL SECURE AND STABLE.
The Bar Stool/Counter Stool now is ready for use.
After a period of use, you may find the Bar Stool/Counter Stool joints, may become loose.
Get the Allen Key and tighten up all Bolts.
This Bar Stool/Counter Stool can only be used on a flat, level surface.
To Next Page
Loading...
