overstock BAR STOOL - Step 4; Step 5

Step 4
5.1 Keep the chair still turned upside down. (legs facing skywards) on the table for the final leg of this
assembly process.
Place the assembled Swivel Plate (D) upside down to the seat frame as shown above.
5.2 Turn the Swivel Plate (D) to 45° degree position as shown above.
Align the mounting Position of the Swivel Plate (D) to the the mounting Position of the Seat Frame.
Affix the with Swivel Plate (D)with the Bolt③, Flat Washer⑥, and Allen Key⑦by using Hardware Pack
D.
Partially Screw in these four Bolts into the Swivel Plate (D).
Turn in all the Bolts.
At this stage, FULLY TIGHTEN THE BOLTS.
Step 5
5.2
5.1
4.1 4.2
4.1 Place the Cushion Seat (E) upside down on a table edge.
Align the Backrest Panel to the Seat Frame.
4.2 Align the mounting position of the Cushion Seat (E) to the mounting position in Backrest (A) .
Affix the Backrest frame to the Seat Frame with the Bolt , Spring Washer④ , Flat Washer ⑥and Allen
Key ⑦by using Hardware Pack C.
Partially drive in all the Bolts in this part of assembly.
Once all Bolts in position, turn in these Bolts.
At this stage,FULLY TIGHTEN THE BOLTS.
D
Pack C
Pack D
Page 6 OF 8