%&'"()*+,,-,,.".
.
Rev. Changes
PA1 - First release
PA2 - Flashing procedure updated, included flashing procedure from SD 42
- systemd 50
- Consumption table updated 56
PA3 - Flashing procedure updated 42
- accelerometer and gyroscope axis images included 34
PA4 - Battery capacity value corrected 23
- Fakra IP67 warning added
- TFTP image flashing warning added 43
PA5 - Internal BT/WiFi antenna position image included 10
PA6 - M12 pin out of Ethernet signals corrected 13
PA7 - Fixing the unit instructions included 54
- Images included for rear back covers 11
- UBIFS image creation instructions updated 44
- Vout max current updated 28
- Kline pinout corrected 29
- Instructions added to create image from current FS in the owa4x 46
- u-boot customization with OTA upgrade example added 39
PA8 - mount command corrected 46
- flashing commands simplified 42 43
- included description of owa4x protections 5
- include a note about UBIFS and command df 44
- power consumption table updated 56
PA9 - impedance values information updated for the inputs 25
- DK DIO usage warning 16
- ubinize commands extended for different FW and HW versions 44
PA10 - Power management table updated with CAN wake up source for Standby Mode 37
- Backup FS new version described 47
- OwaTurnOff new command 37
PA11 - Example flashupdate variable updated 39
- Included AIN1 impedance in machine connector section 25
- Tar command to get running FS improved 46
RB1 - TPM option 36
- CAN3 and CAN4 support of CAN-FD 35
- Power voltage updated to 9V to 36V for owa4x HW R4 25
- GSM table for 4G added 57
1,
To Next Page
Loading...