))
The owa4X Integrators Manual describes how to install, set up, and configure owa4X
Platform product.
The owa4X device can be provided with battery backup as an option. In this case, the
product is labelled with a “/b” at the end, e. g.: owa4X/b.
This first section provides a brief overview of the product followed by a “Getting Started”
chapter. Further sections go into more detail on the hardware specifications and various
firmware functions available to the development of the user application. Application notes,
technical specifications, troubleshooting, and a peripheral devices reference, complete this
manual.
12'
The owa4X product provides a powerful platform for management of geographically
distributed equipment. The owa4X unit integrates a GSM/GPRS communication system
with embedded IP functionality, allowing an efficient and bi-directional transmission of
information across the cellular wireless network. Additionally, the owa4X unit includes a
GNSS receiver for reception of positioning information.
The basic features of this product are:
Cortex A8 with 512MB DDR3 and 1GB NAND Flash
Linux Kernel 4.4.19 or 4.14.67
Debian Filesystem
User-friendly programming environment with a complete set of APIs.
UMTS/HSPA+: Five Band 800/850/900/1900/2100MHz
GSM/GPRS/EDGE: Quad Band GSM 850/ EGSM900 / GSM1800/ GSM1900.
GNSS Receiver 72-channel with -160dBm tracking and navigation sensitivity
Extensive range of external interfaces (RS-232, digital and analog I/Os…).
CAN interface.
Programmable 3 axis accelerometer.
MicroSD card holder.
Optional feature are:
Audio CODEC
Ethernet 10/100
Dead reckoning
Programmable 9 axis sensor, (accelerometer, gyroscope, magnetometer)
Kline
IP67 enclosure
Internal antennas
WiFi + BT module
Up to 4 CAN bus interfaces.
USB
Check data sheet and product variants for the exact features available in your device.
&00)
To Next Page
Loading...
General