1.Safety Information
Operating Steps:
1. Enable the frequency/period measurement.
Press on the front, in the right menu, press the Mode softkey to switch
between Freq and Period measurement.
2. Connect the test lead.
3. Note
Frequency range: 20 Hz to 60 MHz.
750 V input protection is available in all ranges.
4. Set the relative value.
Press the Rel softkey to turn on or o the relative operation. For relative
operation, the multimeter subtracts the pre-specied value of REL operation
from the actual measurement result and displays the result. See page 29,
Relative Value.
To Next Page
Loading...
