[6] Specifications are for amplitude of sine wave input > 5% of range.
For inputs from 1% to 5% of range, add
0.1% of range extra error.
[7] Specifications are for 2–wire ohms using the relative operation of math. Without relative operation, add
±0.20 Ω additional error in 2-wire ohms function.
[8] Except for special marks, when frequency ≤ 10M Hz, the specification is applicable to >1V AC input voltage,
when frequency > 10 MHz, the specification is applicable to >3V AC input voltage.
[9] Specifications are for using the relative operation of math. Using of non-film capacitor may generate
additional errors. Specifications are for from 5% to 110% on ranges.
General Specifications
To Next Page
Loading...
