5.Use the Multimeter (Optional)
(2) In the right menu, set the number of waveform points, the interpolation, and edit the
waveform points. Save the waveform to internal storage or USB device.
File Browse
To read a waveform stored in internal storage or USB device:
(1) Push button. Select Arb in the bottom menu, select Others in the right menu,
and select File Browse.
(2) Select the desired waveform file in internal storage (FLASH) or USB device
(USBDEVICE).
(3) Select Read in the right menu.
Built-in Waveform
There are 46 built-in Arbitrary waveforms. Steps for selecting the built-in waveform:
(1) Push button to show the bottom menu of generator.
(2) Select Arb in the bottom menu, select Others in the right menu, and select Built-in.
(3) Select Common, Math, Window or Others in the right menu. E.g. select Others.
(4) Turn the M knob to select the desired waveform (or touch if the LCD is touchscreen).
E.g. select Noise. Select Select to output the noise waveform.
5. Use the Multimeter (Optional)
Input Terminals
The input terminals are on the back of the oscilloscope, which marked as 10A, mA, COM,
V/Ω/C.
Figure 5-1 Multimeter Input Terminals
To Next Page
Loading...
