User Manual - FUNSTRIP LED V1.0 05/2021 6/24
Power:
Before plugging your unit in, be sure the resource voltage in your area matches the unit
required voltage.
The unit is available in a 230V version only. Because the line voltage may vary from venue to
venue, you should be sure to plug the socket into a matching wall outlet before attempting to
operate your unit.
Fuses:
The LED Funstrip DMX electric system is protected by T3.15A 250V 5*20mm. Please see the
printing on the case and these fuses prevent you from overloading damaging your unit. To
replace the protective fuse, use a flat head screwdriver to unscrew the fuse holder. Pull out
the old fuse and replace it with a new one.
Insert the fuse back into the slot and tighten. Always replace with exact same type fuse
removed unless otherwise specified by an authorized service technician..
5. System connection
To Next Page
Loading...