Installation
The installation here assumes that the RT and any RT-Range systems have been installed in the
vehicle already according to the instructions in their manual(s). The installation here covers the RT-
XLAN and how to attach it to the vehicle and to the RT3000 v3 or RT-Range S.
For any installation it is essential to have one RT-XLAN base unit. This would normally be in the
hunter vehicle but it can be in any vehicle. One or more RT-XLAN client unit(s) can be installed in
other vehicles; normally these would be installed in the target vehicles.
In environments where more than one RT-Range is being used the RT-XLAN bases will interfere with
each other. It is essential to only have one RT-XLAN base unit at any one location. When more than
one RT-Range system is being used at the same location and two RT-XLAN bases are needed,
contact OxTS support for further help.
Mounting to the vehicle
The base of the RT-XLAN is a pump cup suction mount that can be attached to any flat non-porous
surface such as glass or vehicle bodywork. This surface can either be metallic or non-metallic, making
the mount ideal for a wide variety of vehicle placement options. Please refer to the drawings in Figure
2 which show the mounting and removal process.
To Next Page
Loading...