MAINTENANCEOPERATION (cont.)
5. GENERAL MAINTENANCE
1. Ball bearings are packed with grease at the factory. No further
lubrication of bearings is required.
2. Lubricate all moving parts periodically. Wipe the column, table and
base with an oily cloth to minimise corrosion.
3. Keep air vents clean of dust and dirt.
4. Remove dust and dirt from the drill press regularly with a soft cloth,
brush or compressed air.
5. If the power cord is damaged, have it replaced by an electrician or a
power tool repairer.
6. Regularly check that all bolts, screws and nuts are securely xed as
these could work loose during normal operation.
7. If the drive belt will not align with
the pulleys. The pulleys may be
worn and need to be replaced. To
remove the pulleys, use the 3mm
hex key provided. Loosen in an anti-
clockwise direction.
Note: Ozito Industries will not be
responsible for any damage or injuries
caused by the repair of the drill press
by an unauthorised person or by
mishandling of the drill press.
WARNING! ENSURE THE DRILL PRESS IS
DISCONNECTED FROM THE POWER SUPPLY
BEFORE PERFORMING ANY MAINTENANCE.
position.
5. Adjust the table to your desired
height and ensure the hole in the
centre of the table is aligned with the
drill bit.
Switch the unit on by pressing the
green (I) button.
6. Slowly rotate the feed wheel
handles to bring the drill bit down
towards the table and into your
workpiece. After drilling a hole,
release the feed wheel handles
slowly to return the chuck to its
original position.
7. Continue the operation until the
task is completed. When completed,
switch the drill press o by pressing
the red (O) button on the switch.
To Next Page
Loading...
