Ozito BDP-500 - Operation Guide; Speed Adjustment; Powering On and Off; Operating the Drill Press

Turning On and O󰀨
Note: The pulley cover is tted with a
safety switch and must be closed to
operate the drill press.
1. Switch the drill press on by pressing
the green (I) button on the switch.
2. Switch the drill press o󰀨 by pressing
the red (O) button on the switch.
3. Secure your workpiece to the table
if possible, use a vice or clamps (not
supplied).
An emergency o󰀨 switch is located at
the front of the drill press to allow quick
access to stop the unit o󰀨. Simply press
this button in, to switch the unit o󰀨. This
button must then be released by rotating
it anti-clockwise before the drill can be
started again.
Operating the drill press
1. Ensure the drill press is switched o󰀨
and disconnected from the power
supply.
2. Loosen the jaws of the keyed chuck
with the chuck key by turning in an
anti-clockwise direction and insert the
selected drill bit into the chuck as far
as it will go.
3. Ensure that the drill bit is centred in
the chuck and tighten the chuck jaws
with the chuck key in a clockwise
direction. Tighten all three holes to
ensure the drill bit is secured evenly
by each jaw.
4. Select your drilling depth and secure
the depth adjustment lock nut in
BDP-500
4. SPEED ADJUSTMENTS
OPERATION
Changing the speed
The speed of the drill press can be changed by adjusting the belts on
the pulley system.
Using a smaller pulley on the spindle side increases the drill speed.
Using a larger pulley on the motor side will also increase the drill speed.
1. Loosen the 2 belt tension knobs.
2. Push the motor towards the
head assembly and tighten
the belt tension knobs.
3. To adjust the belt speed,
move the belts to the
correct pulley step for the
speed required.
See the diagram above for
all belt congurations.
When moving the belt, it
is easier to place the belt
onto
the small pulley rst and then turn it onto the larger pulley.
4. To apply tension to the belt
once it has been tted to a
new speed setting, loosen
the belt tension knobs. Pull
the motor away from the
head assembly and then
re-tighten the belt tension
knob.
A
B
A
B
A
B
OFF ON
50
40
30
20
WARNING! THE POWER SUPPLY FOR THIS
PRODUCT SHOULD BE PROTECTED BY A
RESIDUAL CURRENT DEVICE (RATED AT 30MA OR LESS).
A RESIDUAL CURRENT DEVICE REDUCES THE RISK OF
ELECTRIC SHOCK.
A I
B II
C III
D
1
D - I
500/min
2
D - II
680/min
3
C - I
770/min
4
D - III
830/min
5
B - I
980/min
6
C - II
1100/min
7
B - III
1600/min
8
A - II
2000/min
9
A - III
2500/min
5. Ensure the pulley cover is closed and secured with the
pulley cover screw.