Problem Cause Remedy
Drill press will
not start
Emergency o
button is pressed
Rotate the emergency o
button anti-clockwise to
disengage
Pulley cover not
secured
Check the pulley cover is
closed and lowered correctly
in position
Power cord not
connected to the
mains power supply
Ensure that the power cord is
connected to the mains power
Power fault Check the mains power
supply
Power cord
damage
Use an authorised service
centre to repair or replace
Faulty switch or
motor
Use an authorised service
centre to repair or replace
Noisy operation Incorrect belt
tension
Adjust tension as required
Drill bit burns Incorrect speed Adjust speed as described in
the “Changing the speed”
section
Excessive drill
bit wobble
Bent or damaged
drill bit
Use a new drill bit
Drill bit is not
securely placed in
the keyed chuck
Remove the drill bit and
reinsert correctly, ensure the
chuck jaws are fully tightened
The keyed chuck
is not installed
correctly
Ensure you install the keyed
chuck correctly
Drill bit binds in
workpiece
Belt tension is set
incorrectly
Re-adjust the belt tension
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landll and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
SPARE PARTS
V Volts Hz Hertz
~ Alternating current W Watts
/min
Revolutions or
reciprocation per minute
no
No load speed
Regulator compliance
mark
Hp Horse power
Warning Use eye protection
Use ear protection
WARNING! FAILURE TO UNPLUG YOUR DRILL
PRESS COULD RESULT IN ACCIDENTAL STARTING
CAUSING POSSIBLE SERIOUS PERSONAL INJURY.
TROUBLESHOOTING
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquiries@ozito.com.au
To Next Page
Loading...
