Ozito DPI-5000 - TROUBLESHOOTING; MAINTENANCE; SPARE PARTS

DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landll and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquires@ozito.com.au
SPARE PARTS
Cleaning
• Keep the ventilation vents of the inator clean at all times, if possible,
prevent foreign matter from entering the vents.
• After each use, blow air through the inator housing to ensure it is free
from all dust particles which may build up. Build up of dust particles
may cause the inator to overheat and fail.
• If the enclosure of the inator requires cleaning do not use solvents
but a moist soft cloth only. Never let any liquid get inside the inator;
never immerse any part of the inator into a liquid.
Note: Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the inator by an unauthorised person
or by mishandling of the inator.
Problem Cause Solution
The inator
does not start
Inator not connected
to the power
Connect the unit to
a 12V DC or
230-240V AC outlet
Incorrect power mode
selected
Ensure correct
power mode is
selected with the
power mode switch
Insufcient supply
voltage
Try another power
outlet
12V Fuse needs
replacing
Replace Fuse
The inator starts but
there is no pressure
Loose hose
connections
Check the
compressed air
hose and adaptor
and replace if
necessary
The seals are damaged Check the seals
and have any
damaged seals
replaced by a
service centre
LCD display wont
turn on
Compressor not
connected to the power
Connect the unit to
a 12V DC or
230-240V AC outlet
The unit automatically
stops before the item
is fully inated
Target pressure setting
is set too low
Adjust the target
pressure to the
required value
indicated on the
inatable item
TROUBLESHOOTING
MAINTENANCE
WARNING: BEFORE CLEANING YOUR INFLATOR OR
CARRYING OUT ANY MAINTENANCE PROCEDURE,
ENSURE THE UNIT IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY.
IMPORTANT: STORE THE INFLATOR ONLY IN A DRY LOCATION
WHICH IS NOT ACCESSIBLE TO UNAUTHORISED PERSONS.
ALWAYS STORE UPRIGHT, NEVER TILTED!
WARNING: WAIT UNTIL THE INFLATOR HAS
COMPLETELY COOLED DOWN TO PREVENT BURNS.
A Amps
Double insulated
dc Direct current
l/min Litres per minute
S3 Intermittent periodic duty
mA Milliamperes
PSI Pressure rating
ac /