MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLE SHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landll and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep the ventilation vents of the multipurpose saw clean at all times, if
possible, prevent foreign matter from entering the vents.
• After each use, blow air through the multipurpose saw housing to ensure it is
free from all dust particles which may build up. Build up of dust particles may
cause the multipurpose saw to overheat and fail.
• If the enclosure of the multipurpose saw requires cleaning, do not use
solvents but a moist soft cloth only. Never let any liquid get inside the
multipurpose saw; never immerse any part of the multipurpose saw into a
liquid.
Carbon Brushes
When the carbon brushes wear out, the multipurpose
saw will spark and/or stop. Discontinue use as
soon as this happens. They should be replaced
prior to recommencing use of the multipurpose
saw. Carbon brushes are a wearing component of
the multipurpose saw therefore not covered under
warranty. Continuing to use the multipurpose saw
when carbon brushes need to be replaced may
cause permanent damage to the multipurpose saw. Carbon brushes will wear
out after many uses but when the carbon brushes need to be replaced, take the
multipurpose saw to an electrician or a power tool repairer for a quick and low
cost replacement. Always replace both carbon brushes at the same time.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the multipurpose saw by an unauthorised person or by
mishandling of the multipurpose saw.
Carbon Brush (Pair) SPMSW3000-37
Blade Clamp Spring SPMSW3000-05
Blade Clamp SPMSW3000-06
Screws M5 x 16 SPMSW3000-07
For spare parts visit www.ozito.com.au
Or contact Ozito customer service
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquires@ozito.com.au
SPARE PARTS
V Volts Hz Hertz
~ Alternating current W Watts
/min Revolutions or
reciprocation per minute
Double insulated
Regulator compliance mark
Maximum cutting cap
for timber
Warning
Read instruction manual Wear ear protection
Wear eye protection Wear face mask
no No load speed
The on/off trigger is locked.
Ensure you have correctly held the lock-off switch (located on
the on/off trigger) down.
To Next Page
Loading...
