Ozito TRP-650 - Discharge Outlet; Priming the Pump

2. Using a spanner or
screwdriver remove the
priming screw from the top
of the pump housing by
turning the screw counter
clockwise.
3. Using a hose, ll the pump
completely with water.
Ensure the pump and
inlet pipe or hose are full.
Replace the priming screw.
1 Ensure the pump’s on/off switch is in the off (0) position and off at
the mains power.
2. DISCHARGE OUTLET 3. PRIMING THE PUMP
3. Securely attach the output
hose or pipe to the other
end of the adaptor. Ensure
you have the correct
diameter hose or pipe that is
compatible with your water.
discharge application.
2. Remove the plastic protection
cover from the discharge outlet
and insert a 1” male threaded
hose adaptor (not included)..
WARNING!: THIS PRODUCT IS INTENDED
FOR PUMPING WATER IN A HOME DOMESTIC
APPLICATION. DO NOT USE IT FOR CORROSIVE,
ABRASIVE, EXPLOSIVE OR DANGEROUS LIQUIDS.
NOTE: The discharge hose or pipe you are using
must have a minimum diameter of 19mm (3/4’’).
NOTE: Ensure the discharge hose or pipe is not
restricted in any way and no pressure is obstructing
the hose or pipe when the pump is in operation.
Priming the pump is required to purge air from the hose
Don’t operate the pump without being primed.
1. Teon tape (not included) is
required on threads to ensure
a water tight seal and prevent
any leakage. Wind Teon
clockwise on ttings
Slowly ll
with water
Connecting Hose or Pipe to the Discharge Outlet